300-410, question bank, please

willleeforwork1

QUESTION & nbsp; In which two ways does the IPv6 First-Hop Security Binding Table operate? ( Choose two.)

A. by the recovery mechanism to recover the binding table in the event of a device reboot

B. by IPv6 routing protocols to securely build neighborships without the need of authentication

C. by IPv6 HSRP to make sure neighbors are authenticated before being used as gateways

D. by various IPv6 guard features to validate the data link layer address

E. by storing hashed keys for IPsec tunnels for the built-in IPsec features


ANS. & nbsp; A D


QUESTION



Bangkok is using ECMP to reach to the 192.168.5.0/24 network. The administrator must configure Bangkok in such a way that Telnet traffic from 192.168.3.0/24 and 192.168.4.0/24 networks uses the HongKong router as the preferred router.



Which set of configurations accomplishes this task?

A . access-list 101 permit tcp 192.168.3.0 0.0.0.255 192.168.5.0 0.0.0.255 eq 23

access-list 101 permit tcp 192.168.4.0 0.0.0.255 192.168.5.0 0.0.0.255 eq 23

route-map PBR1 permit 10

match ip address 101

set ip next-hop 172.18.1.2

interface Ethernet0/3

ip policy route-map PBR1



B . access-list 101 permit tcp 192.168.3.0 0.0.0.255 192.168.5.0 0.0.0.255 eq 23

access-list 101 permit tcp 192.168.4.0 0.0.0.255 192.168.5.0 0.0.0.255 eq 23

route-map PBR1 permit 10

match ip address 101

set ip next-hop 172.18.1.2

interface Ethernet0/1

ip policy route-map PBR1



C . access-list 101 permit tcp 192.168.3.0 0.0.0.255 192.168.5.0 0.0.0.255 eq 23

access-list 101 permit tcp 192.168.4.0 0.0.0.255 192.168.5.0 0.0.0.255 eq 23

!

route-map PBR1 permit 10

match ip address 101

set ip next-hop 172.18.1.2

!

interface Ethernet0/1

ip policy route-map PBR1



D . access-list 101 permit tcp 192.168.3.0 0.0.0.255 192.168.5.0 0.0.0.255 eq 23

access-list 101 permit tcp 192.168.4.0 0.0.0.255 192.168.5.0 0.0.0.255 eq 23

!

route-map PBR1 permit 10

match ip address 101

set ip next-hop 172.18.1.2

!

interface Ethernet0/3

ip policy route-map PBR1




ANS. A



QUESTION


Which two components are needed for a service provider to utilize the LVPN MPLS application?( Choose two.)

A. The P routers must be configured for MP-iBGP toward the PE routers

B. The P routers must be configured with RSVP.

C. The PE routers must be configured for MP-iBGP with other PE routers

D. The PE routers must be configured for MP-eBGP to connect to CEs

E. The P and PE routers must be configured with LDP or RSVP


ANS.A D


I‘m not sure about these three questions. I‘d like to hear your opinions


Which two components are needed for a service provider to utilize the LVPN MPLS application?