Question 2 about 300-410

dicky_wong617

When configuring Control Plane Policing on a router to protect it from malicious traffic, an engineer observes
that the configured routing protocols start flapping on that device. Which action in the Control Plane Policy
prevents this problem in a production environment while achieving the security objective?
A. Set the conform-action and exceed-action to transmit initially to test the ACLs and transmit rate and apply
the Control Plane Policy in the output direction
B. Set the conform-action and exceed-action to transmit initially to test the ACLs and transmit rate and apply
the Control Plane Policy in the input direction
C. Set the conform-action to transmit and exceed-action to drop to test the ACLs and transmit rate and apply
the Control Plane Policy in the output direction
D. Set the conform-action to transmit and exceed-action to drop to test the ACLs and transmit rate and apply
the Control Plane Policy in the input direction

I don‘t understand the difference between drop to test and transmit initially to test ACL. Please give us your opinions and solutions. Thank you!!!
















About control plane policy